Wire/Function |
CM4200 |
Colour |
Location/Description |
Polarity |
12 VOLTS |
RED & RED/WHITE(CN1) |
White/blue |
Ignition switch harness |
+ |
IGNITION |
GREEN (CN1) |
Blue/yellow |
Ignition switch harness |
+ |
IGNITION 2 |
BLUE (CN1) |
Black/red |
Ignition switch harness |
+ |
ACCESSORY |
WHITE (CN1) |
Runs with ignition wire |
|
|
STARTER |
YELLOW (CN1) |
Black/white |
Ignition switch harness |
+ |
STARTER 2 |
RED/BLACK (CN2) + Relay |
Green/black |
Ignition switch harness |
+ |
KEY SENSE |
|
Green/black |
Ignition switch |
- |
TACH SIGNAL |
YELLOW/BLACK (CN3) |
See notes |
|
|
|
|
the 2.4L and the 2.7L
engine, there are 2 coils on the left front of the engine. Use
the BLACK/BLUE or BROWN/YELLOW for a 2 cylinder signal. On the
3.4L engine there is a coil per cylinder. Use the wire opposite
from the BLACK/RED at any of the coils. With any of the engines
you can also find a BLACK tach reference at pin-15 of the 26-pin
connector on the ECM behind the glovebox.
|
|
FUEL INJECTOR |
|
Opposite from Black/red |
At any injector on engine |
AC |
LOCK |
BLUE/BLACK (CN4) |
Blue/white |
In driver's kickpanel |
- |
UNLOCK |
BLUE (CN4) |
Green/black (double pulses) |
In driver's kickpanel |
- |
DOORPIN |
RED/WHITE(+) or RED(-) (CN3) |
SEE NOTES |
|
|
|
|
GREEN (driver's door),
GREEN/WHITE (passenger door), YELLOW/GREEN (rear doors). All 3
wires are found in a 22-pin connector on the front of the
fusepanel under the dash. Isolate with 1N4001 diodes if
connecting together.
|
|
BRAKESWITCH |
LT.BLUE/WHITE (CN3) |
Blue |
At switch above brake pedal |
+ |
PARKLIGHTS |
GREEN/WHITE (+) (CN1) or (-) (CN2) |
Green |
Parking light switch |
- |
HAND BRAKE |
LT.BLUE (CN3) Manual only |
Green/white |
At switch on handbrake lever |
- |
HORN |
WHITE (-) (CN2) |
Green/red |
At steering column |
- |
CLUTCH SWITCH |
Manuals only (see inst. Guide) |
Black/white |
At switch on top of clutch pedal |
TYPE 1 |
DRIVER WINDOW UP |
|
Blue/yellow |
At master window switch |
REV POL |
DRIVER WINDOW DOWN |
|
Blue/green |
At master window switch |
REV POL |
PASSENGER WINDOW UP |
|
Red/black |
At master window switch |
REV POL |
PASSENGER WINDOW DOWN |
|
Red/green |
At master window switch |
REV POL |
HEADLIGHTS |
|
Red/blue or Red/green |
At light switch harness |
- |
REVERSE LIGHTS |
|
Red/black |
In driver's kickpanel |
+ |
DIMMER |
|
White/green |
At harness behind dimmer switch |
+ |
VSS WIRE |
|
Green/orange |
At ECM behind glovebox |
|
|
|
The GREEN/ORANGE vss wire is
located on the ECM behind the glovebox. On the 2.4L and 2.7L,
it's at pin-8 of the 22-pin connector. On the 3.4L, it's at
pin-12 of the 28-pin connector.
|
|
|
N/A
|
|
WHEN PROGRAMMING THE PATS TOYOTA THE BLACK WIRE FROM PATS TOYOTA
MODULE TO GROUND FIRST. AFTER THE BLACK WIRE IS GROUNDED GROUND
THE BLUE KEY SENSE WIRE ON THE IGNITION BARREL. DO NOT GROUND AT
THE SAME TIME.
|
رموت , ريموت ,مفاتيح
, مفتاح, إنذار ,
wires, diagram , alarm , stereo , مسجل , مسجله , توصيلات ,
أسلاك