|
12volts black (30A), orange (7.5A) + ignition harness Starter blue +
ignition harness Second Starter red + ignition harness Ignition yellow +
ignition harness Second Ignition green + ignition harness Third Ignition
N/A Accessory gray + ignition harness Second Accessory N/A Keysense
black - ignition harness Notes: Using the status output from the remote
start to trigger this wire will disarm the factory alarm without unlocking the
doors. Power Lock black to brown - driver kick, 20 pin plug, pin 9
Notes: Meter this wire while turning the key in the driver door key cylinder.
Power Unlock gray to purple (double pulse) - driver kick, 20 pin plug, pin
19 Notes: Meter this wire while turning the key in the driver door key
cylinder.
Can also use the passenger door key cylinder wire, which only
requires a single pulse. It is gray to yellow (-) in the passenger kick, 20 pin
plug, pin 8. Lock Motor red to white 5wi driver kick, 20 pin plug, pin 1
Unlock Motor white to gray 5wi driver kick, 20 pin plug, pin 20 Parking
Lights+ do not use, relay rests at gnd Parking Lights- blue - headlight
switch Hazards yellow - switch or turn signal flasher, pin 8 Notes: The
turn signal flasher is under the driver side dash, against the firewall.
Turn Signal(L) black + turn signal flasher, pin 3 Notes: The turn signal
flasher is under the driver side dash, against the firewall. Turn Signal(R)
pink + turn signal flasher, pin 2 Notes: The turn signal flasher is under
the driver side dash, against the firewall. Reverse Light pink to black +
driver kick, 17 pin plug, pin 2 Door Trigger see notes - each kick, harness
to rear Notes: The LF door is pink to blue, RF door is purple to blue, LR
door is black, and RR door is gray. Use all four wires and diode isolate each.
Dome Supervision brown - R side of fusebox, 12 pin plg, pin 5
Trunk/Hatch Pin white to purple - driver kick, blu 20 pin plug, pin 17 Hood
Pin blue - pin switch under hood Trunk/Hatch Release blue - trunk release
switch on dash Notes: The trunk release motor wire is black (5wi) in the
driver kick, blue 20 pin plug, pin 11.
The fuel lid release is gray to
green (+) at the release switch on the dash or in the driver kick, blue 20 pin
plug, pin 15. Power Sliding Door N/A Factory Alarm Arm arms with lock
Factory Alarm Disarm disarms with unlock Disarm No Unlock use key sense
wire Tachometer white ac ECM, second plug from top, pin 1 Notes: The ECM
(Engine Control Module) is behind the glove box.
Can also go to any fuel
injector and use the wire that is NOT brown. Wait to start N/A Brake
Wire white + brake pedal switch Parking Brake lt. green - parking brake
switch Horn Trigger gray - horn switch in column cover Memory Seat 1
green - memory seat switch in door Memory Seat 2 purple - memory seat switch
in door Memory Seat 3 N/A - Interface Module: Category: Immobilizer
Bypass Required: Yes Type: Transponder Part #: 556UW Alternate
Part1 #: DesignTech 20402 Alternate Part2 #: DesignTech 29402 Notes:
Smart Starter Kill Relays: Not Available
warning This wiring
information is being provided free of charge on an "as is" basis, without any
representation or warranty. It is your responsibility to verify any circuit
before interfacing with it using a digital multimeter. Directed Electronics
assumes no responsibility with regards to the accuracy or currency of this
information. Proper installation in every case is and remains the responsibility
of the installer. DEI assumes no liability or responsibility resulting from
improper installation, even in reliance upon this information.
|