DIRECTWIRE� WIRING INFORMATION - VOLVO / C70 / 2004 / Remote Start


12volts red (10A)   +   ignition harness
Notes: This wire is rated at 10 amps only. If installing any system with high current outputs, go to battery for 12V.
Starter yellow/white   +   ignition harness
Second Starter
Ignition green/yellow   +   ignition harness
Second Ignition blue/yellow   +   ignition harness
Third Ignition          
Accessory yellow/purple   5wi ignition harness
Second Accessory          
Keysense yellow (required)   +   ignition harness
Power Lock yellow/gray   -   keyless module
Notes: The keyless entry module is located above the hood release. It is a black box with 2 green plugs.
Power Unlock gray/red   -   keyless module
Notes: The keyless entry module is located above the hood release. It is a black box with 2 green plugs.

Requires a double pulse for unlock.
Lock Motor yellow   5wi driver kick, door harness
Unlock Motor blue/brown   5wi driver kick, door harness
Parking Lights+ white   +   headlight switch
Notes: If the vehicle has factory daytime running lights, and you use the white at the switch for parking lights, the headlights will flash as well. The solution is to wire it as a 5 wire system. Also, there are two white wires at the switch. They go to the same pin. Treat them like one wire.
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light          
Door Trigger pink/black   -   keyless module
Notes: The keyless entry module is located above the hood release. It is a black box with 2 green plugs.

To avoid the dome light delay, there are 2 separate door trigger wires at the keyless module. They are: LF white/black, RF yellow/brown. Both wires are negative trigger and must be diode isolated from each other.
Dome Supervision comes on with unlock
Trunk/Hatch Pin blue/brown   -   keyless module
Notes: The keyless entry module is located above the hood release. It is a black box with 2 green plugs.
Hood Pin yellow/black   -   keyless module
Notes: The keyless entry module is located above the hood release. It is a black box with 2 green plugs.
Trunk/Hatch Release yellow/white   -   keyless module
Notes: The keyless entry module is located above the hood release. It is a black box with 2 green plugs.
Power Sliding Door
Factory Alarm Arm arms with lock
Factory Alarm Disarm disarms with unlock
Disarm No Unlock single pulse unlock wire
Tachometer NOT red, black, or yellow   ac   any ignition coil
Wait to start
Brake Wire yellow   +   brake pedal switch
Parking Brake
Horn Trigger yellow/red   -   keyless module
Notes: The keyless entry module is located above the hood release. It is a black box with 2 green plugs.

This triggers the alarm horn, the vehicle horns only work with the ignition on.
Memory Seat 1
Memory Seat 2
Memory Seat 3
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Transponder
Part #: 556UW
Alternate Part1 #: 555U
Notes:



      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.