:: مهندس ::
تاريخ التسجيل: Aug 2007
المشاركات: 41
|
|
نشاط [ mushtak22 ]
قوة السمعة:0
|
|
21-05-2008, 10:51 PM
المشاركة 3
|
|
1.- Stop, 0, stop, 1; will get to Tech modes. 2.- Press one for tech card 1, 3.- Press the key above OK key 4 times (until the erase 4 ligths up). On the Screen, you will see the toner count and set. Erase the count counter but do not erase the set (unless you know what are you messing with). Note: make sure you took out the wasted toner from the back of the machine panel reset to get out
INTERMITTANT "OUT OF PAPER" LIGHT
Paper empty senor prone to collect paper dust. Clean sensor with canned air or blower brush.
STOPS DURING MULTICOPY
During multicopy machine will count down ok but stops after every copy cycle. User must push print button every time to get all of copies. Replace ATDC sensor. Sensor checks for correct toner mix after every cycle. If senor becomes flaky it will cause the machine to stop after every copy cycle.
The control panel LEDs are out.
There are two rows of black boxes in the LCD display. The copier appears to be ready to copy - heat lamp cycles and all, however the print key as well as all others are dead. Replace the PWB-B this corrected the problem.
EP-2050 TONER RESET
1.- Stop, 0, stop, 1; will get to Tech modes. 2.- Press one for tech card 1, 3.- Press the key above OK key 4 times (until the erase 4 ligths up). On the Screen, you will see the toner count and set. Erase the count counter but do not erase the set (unless you know what are you messing with). Note: make sure you took out the wasted toner from the back of the machine panel reset to get out
2080
|